Page 1 of 1
Design Calculation for Leak Sealing Clamps
Posted: 18 Oct 2010, 17:13
by qaisarabbas
Does someone has the standard drawings of split sleeve clamps used for online leak rectification?
Or any kind of excel / software based design calculations?
Regards
Re: Design Calculation for Leak Sealing Clamps
Posted: 19 Oct 2010, 05:37
by octane
For which type of leakage rectification you want to design a split sleeve clamp?
On flanges / piping?
Re: Design Calculation for Leak Sealing Clamps
Posted: 19 Oct 2010, 05:44
by ashfaqanwer
Qaisar,
If you are talking about a leak sealing clamp for flanges, I can provide you a design calculation sheet in excel.
Please confirm if you want the same.
Re: Design Calculation for Leak Sealing Clamps
Posted: 19 Oct 2010, 10:58
by qaisarabbas
Octane: I am interested in general clamp designing for both flange & piping.
Ashfaq: Please share the calculations sheet for flanges.
Re: Design Calculation for Leak Sealing Clamps
Posted: 20 Oct 2010, 12:32
by ashfaqanwer
Attached please find an excel sheet for sealing clamp design calculations.
These calculations are for round clamps (split sleeve bolted) used for sealing flange leakages.
Re: Design Calculation for Leak Sealing Clamps
Posted: 20 Oct 2010, 14:51
by octane
Thanks...
Re: Design Calculation for Leak Sealing Clamps
Posted: 23 Oct 2010, 15:09
by qaisarabbas
Thank you Ashfaq for calculation sheet. Would appreciate if some drawings be also shared.