Page 1 of 1
repair /modification of regulated pressure vessels
Posted: 18 Jul 2010, 11:07
by MECHRI
Dear All;
I would like to know the Standrads that address the classification of repairs or/and modifications of the regulated pressure vessels.
Re: repair /modification of regulated pressure vessels
Posted: 18 Jul 2010, 12:34
by arcpro
ASME addresses almost all the repairs need to be carried out in post construction phase of any facility. They have formulated a committee which deals with these repairs, ASME PCC (ASME Post Construction COmmittee). ASME PCC-2 deals with "Repair of Pressure Equipment of Piping". All the repairs have been classified and taken care of in a systematic manner.
Go through PCC-2 you would surely be finding your solution.
Re: repair /modification of regulated pressure vessels
Posted: 18 Jul 2010, 13:14
by MECHRI
thanks Mr. arcpro
Re: repair /modification of regulated pressure vessels
Posted: 18 Jul 2010, 14:06
by arcpro
MECHRI,
No problems.
If you have any other question regarding this, you may feel free to pen down.
Re: repair /modification of regulated pressure vessels
Posted: 18 Jul 2010, 15:33
by qaisarabbas
There is another code relevant to your requirement: NBIC NB-23 (Part 3 - Repairs and Alterations)
Re: repair /modification of regulated pressure vessels
Posted: 27 Jul 2010, 08:31
by arcpro
Qaisar,
Can you please add some information regarding NBIC NB-23? Scope? Comparison with ASME PCC-2?