Page 2 of 2
Re: Counter Weights - Thermal Expansion System @ Furnace
Posted: 09 Nov 2010, 17:10
by mechcolor
Abbas,
It's a good document.
Re: Counter Weights - Thermal Expansion System @ Furnace
Posted: 10 Nov 2010, 21:02
by mechcolor
I do not know to which extent this article will help you.
See attached file.
Re: Counter Weights - Thermal Expansion System @ Furnace
Posted: 11 Nov 2010, 17:56
by qaisarabbas
Yes, this is quite helping article as far as next revamp of our primary reformer is concerned. We are thinking on the same lines and thus engaged a consultant for:
- Replacing counterweight system with constant spring support system
- Upgrading metallurgy of Catalyst tubes from HP-modified to Microalloy
- Changing staggered arrangement to in-line tubes pattern
- Adding new pre-mix burners
Thank you Mechcolor ! Appreciate your knowledge sharing.