PetroStreet

So nice of you Qaisar for your appreciation.

Kudos! ! !.... to thepetrostreet developers' team ! ! !
Really a handy thing!!
very helpful for non-inspection engineers too.

A useful utility.
I would like to add a comment here.
In one instance of fluid type and service conditions ASME B31.3 explicitly mentions that no provisions for this fluid service that is if a fluid is high pressure (rating > 2500) and toxic also, code says to review if category M fluid service apply and if it does not than code makes no provision for this fluid service. On the contrary, in NDT Shop, it's good that the stringent of the two requirements for examination has been mentioned but my suggestion is that the developer must add this note also under 'more' click.

Thanks for developing and sharing an easy to use tool.

The good point over here is that NDT requirements, once specified, are a very straightforward thing unlike designing - you may require say 10%RT and so on and so forth. However, specifying them may not be very easy for a less experienced Engineer. This software removes that barrier and even a dunce can manage it on his own now.

Not bad at all!

Qaisar & kamran,
Thanks for your appreciation.

arcpro,
A very valid input. I would add that point in the next release, additionally I would also be adding one more point "only for non-metallic piping".
Thanks for providing your comments.

Any time, this title is coming back?

We are eager to have PetroSofts back, all of them however, as of now, there has not been any confirmed release dates available.

irish wrote: 25 Aug 2025, 06:01 Any time, this title is coming back?